Futaba SBS-01V - Manual (Page 2)

cable
Measure the cable and then cut it to the desired length.
Cut approximately 30mm of the negative (-, black) line from the cable.
Solder the fuse inline on the negative wire and then reattach the section of wire
that was previously removed. The fuse should be attached as close to the
external power supply as possible.
Place a piece of heat shrink tubing over the fuse, ensuring that it covers the
soldered areas. Shrink the tubing snug to the fuse and the wire using a heat gun.
The cable should be connected as shown in the diagram below. The cable
gets connected to the wires that come off the ESC and connect to the battery.
The manual for the Telemetry system should be referred to after the setup is
complete; checking to make sure it functions as desired and that it provides the
correct voltage on the display.
The fuse should be attached as close to the
external power supply as possible.
Heat shrink tube
Fuse to Black line (－)
Heat shrink tube
Heat shrink
The connection is affixed to the ESC on the wires
that are connected to the battery by soldering them
and then protecting them with heat shrink.
To Power Battery
To Receiver S.BUS2 port
To Motor
Fuse（mount in either direction）
Fuse
Solder welding
motor
controller
The wiring processing method of an EXT Line
FUTABA CORPORATION
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
©FUTABA CORPORATION 2012, 10 (1)