Futaba GY611 - Manual (Page 19)

19
D
ATA
S
ETTING
Flight mode
Initial value : F3C
Switches the flight mode. Settings are F3C or 3D.
The F3C mode emphasizes tail suppression and stop. The 3D mode
slightly sacrifices tail suppression and stop, but lets you control pir-
ouette speed completely proportional with the rudder stick operation
amount and is suitable for 3D flight.
<3D mode steering angle setting>
· During 3D mode setting, the transmitter rudder steering angle is set to 100%
and approximately 500º/second high pirouette speed. Therefore, initially set
the transmitter rudder steering angle to a low value so that the tail can be
safely controlled. (About 70%)
The pirouette speed is proportional to the rudder steering amount without re-
gard to the gyro sensitivity.