Futaba GY611 - Manual (Page 24)

24
D
ATA
S
ETTING
When Using a T14MZ Transmitter Gyro Mixing
The Gyro Mixing (Gyro) function lets operator perform three-point gain ad-
justment at each condition. Set the sensitivity at all conditions.
[GY611 Settings]
Select the gyro operation mode at the GY611 Mode screen. (AVC, NOR, or
CMT)
[Transmitter Settings]
End Point (ATV) function:
Adjust the both travels to 100% at the transmitter 3ch(Gyro) End Point func-
tion setup screen. (H-4 Swash: Sensitivity setting is assigned to 7ch.)
Gyro Mixing function:
1. Activate the function at the transmitter Gyro Mixing setup screen.
(If two or three rates are activated, select the selector switch.)
2. Set the type of gyro to GY.
3. Select the desired mode (AVCS or Nor) and adjust the gyro sensitivity by
rate.
(The following page shows a setting example in the CMT mode.)
[Sensitivity Display]
The gain display indicates the actual gain at the GY611 normal screen dis-
play. The following shows the relationship between transmitter and gyro set-
ting .
[Relationship between transmitter and gyro setting]
Transmitter settings: Nor AVCS
100% - 0% - 100%
Normal mode
AVCS mode
Normal mode AVCS mode
Actual gain: 100% - 0% - 100%
NOR:
AVC:
CMT:
GY611 mode
settings: