Futaba GY611 - Manual (Page 31)

31
D
ATA
S
ETTING
[During use]
When the rudder was re-trimmed in the Normal mode and the new
trim position also affects the AVCS mode, the rudder trim neutral po-
sition must be memorized in the GY611.
Re-reading method
In this case, quickly switch (interval of within 1 sec-
ond) the transmitter remote gain switch between the
Normal and AVCS sides at least three times and switch
the AVCS side at the neutral trim position set in the
Normal mode. This memorizes the new rudder neutral
position in the GY611.
When the transmitter has a function that allows trim
setting for each flight condition, such as the T9Z and
T14MZ, the AVCS mode trim position is fixed and
this operation is unnecessary.
Never use the transmitter rudder trim in the
AVCS mode.
· When the rudder is trimmed during flight, the neutral posi-
tion will change.
When using the GY611 in the AVCS mode, set
revolution mixing to OFF.
When the rudder neutral position was
changed by the linkage, the rudder neutral
position in the AVCS mode must always be re-
read before use.