Futaba GY611 - Manual (Page 30)

30
D
ATA
S
ETTING
Initialization
AVCS mode operation is based on the rudder neutral data stored in
the GY611. When using the GY611 for the first time, or when the
internal reference data and the transmitter neutral position differed
when the transmitter neutral trim was adjusted, etc., the rudder neu-
tral data must be read again.
Do not move the helicopter until this message
disappears (in about 3 seconds).
Also, do not move the transmitter rudder stick
from the neutral position during this period.
[At power ON]
When the power switch is turned on, the GY611 automatically ob-
tains the reference signal for AVCS function correction and initializes
itself.
· When the power was turned on in the Normal mode, the rudder neutral posi-
tion already memorized in the GY611 is not updated.
· When the power was turned on in the AVCS mode, the rudder signal at that
point is memorized and updated.
Precautions When Turning on the Power
Switch
During initialization, the message ˝-Hello-˝ appears on
the GY611 LCD screen.