Globalstar SmartOne - Manual (Page 34)

SmartOne Manual Rev 1.4 DOC# 9100-0268-01 p.34
Inside Change of Location Area
The parameters in this section define the functionality of the device
while inside its Change of Location Area while in Reduced Messaging
Mode.
Change of Location Range. Change of Location Range specifies the length
(in meters, kilometers, yards, or miles) from the center of the Change
of Location Area.
Message Interval inside the Change of Location Area. The SMARTONE can be
configured to transmit messages while inside the Change of Location
Area. This parameter allows you to configure the message interval inside
the Change of Location Area in days, hours and minutes. In the Reduced
Messaging Mode, the asset will send infrequent messages if asset is in
its Change of Location Area.
Position Check Interval while in State of Vibration. The SMARTONE can be
configured to check GPS coordinates at a rate different from the
transmission rate. This interval will determine the accuracy in time on
how quickly the device will sense that it has left its Change of
Location Area.
Vibration Sensor Settings Button. This button activates the Vibration
Settings window. This window contains settings to define how the
vibration sensor determines that the
SMARTONE is In Motion. The
parameters include Level of Sensitivity for Vibration Sensor, Time to be
in a State of Vibration and the Time to be in a State of Lacking
Vibration.