Globalstar SmartOne - Manual (Page 74)

SmartOne Manual Rev 1.4 DOC# 9100-0268-01 p.74
is configurable during the tracker set up process. Globalstar only
counts repeated messages as one message if it is received three times or
less. If the same message is receive more than three times Globalstar
may count the message as more than one message for billing purposes
S
Self Test – An internal unit test that is performed by the processor.
The test checks for proper operation of functions that can be tested by
the processor.
State of lacking Vibration – The vibration sensor is indicating a cease
of vibration when the number of vibration pulses per minute is lower
than the Level of Sensitivity for Vibration Sensor number for the time
required to determine if a State of Vibration has ceased.
State of Vibration – The vibration sensor is in a State of Vibration
when the number of vibration pulses per minute exceeds the Level of
Sensitivity for Vibration Sensor for the time required to detect a State
of Vibration.
T
Time to be in a State of Lacking Vibration– a configurable parameter
that sets the period of time vibration has to be absent to determine if
a State of Vibration has ceased.
Time to be in a State of Vibration – a configurable parameter that sets
the period of time used to determine if a State of Vibration exists.
U
Undesired State Message – The SMARTONE sends this message at a user
defined interval while any of its Inputs are in the closed or opened
state depending on the user selection