Globalstar SmartOne - Manual (Page 42)

SmartOne Manual Rev 1.4 DOC# 9100-0268-01 p.42
Time to be in a State of Lacking Vibration. Time the vibration sensor
must be below the sensitivity level before in a State of Lacking
Vibration.
Outside Change of Location Area
The parameters in this section define the functionality of the device
while outside its Change of Location Area.
Change of Location Alert Messages. The SMARTONE can be configured to
send Change of Location Area Alert messages when the device leaves the
Change of Location Area. This special message can be processed by the
back office application to send a notification to a cellular phone or to
an email account that the asset has left the authorized Change of
Location Area. The number of Change of Location Area Alert messages sent
by the device is configurable with range from 1 to 3. The message
interval of the Change of Location Area Alert message will be the same
as the In Motion Message Interval outside the Change of Location Area.
In Motion Interval. This parameter determines the message interval once
device is outside the Change of Location Area and In Motion.
In Theft Recovery Mode, the device will continue to send messages
outside it Change of Location Area at the specified In Motion message
interval until the device is Re-Centered by turning the connector in the
device in the OFF and ON position.
The device will create a new Change of Location Area in the Theft
Recovery Mode immediately after turning ON the device using the
connector.
At Rest Interval. This parameter determines the message interval once
device is outside the Change of Location Area and At Rest. The device is
considered to be at rest when the comparison of a new GPS reading to a
previous GPS reading indicates that the tracker has not changed location
by more than a specified minimum distance.