Golden Lighting 1208-1W DNI - Manual

Assembly Instructions: 1 208-1W DNI (Marcellis)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important notes
above. Shut off the power at the circuit breaker and completely
remove the old fixture from the wall, including the old mounting
strap.
Mounting strap (B) contains several pairs of threaded holes. Find the
pair of holes that matches the spacing of the holes on the junction
box and your fixture back plate. Two of mounting screws (A) should
be attached to mounting strap (B). You may need to tighten the
nuts that hold these screws in place. Pull the house wires through
the center of mounting strap (B). Place mounting strap (B) over
the junction box so that mounting screws (A) are horizontal, and in
alignment with the hole locations on the fixture backplate (F). Secure
mounting strap (B) to the junction box with mounting screws (D) and
a screwdriver. Tighten the screws securely.
CONNECTING THE WIRES
Attach the fixture’s wires to the power supply wires from the junction
box. Connect black to black (or smooth); white to white (or ribbed);
ground to ground (green or copper). Twist the ends of the wire pairs
together, then twist on a wire connector. Make sure all twists are in
the same direction. If there is no ground wire (green or copper) from
the junction box, locate ground screw (E) on mounting strap (B) and
wrap the fixture ground wire around the green ground screw (E). Use
a screwdriver to secure ground screw (E) onto the mounting bracket.
Tuck all wires neatly into the junction box.
FINISHING THE INSTALLATION
Place fixture backplate (F) over mounting screws (A) so that they
protrude through the holes in the front of the backplate. Thread
deco nuts (G) onto mounting screws (A). Twist until backplate (F) of
the fixture is snug against the wall.
Note: Complete the remaining steps after the fixture is hung.
Tighten the decorative hammered finials (I) onto the threads at the
bottom of the fixture arm.
Carefully slide glass shade (K) over socket (H). Candle sleeve (L)
have retaining rings attached. The retaining ring has two small
holes in each side. The glass shade opening is tight. Carefully push
the candle sleeve down into the glass shade and over the socket.
Carefully place the tips of socket tool (J) into the holes in the
retaining ring. Use socket tool (J) to thread the retaining rings onto
the socket threads. This will secure the glass in place.
Install light bulbs in accordance with the fixture’s specifications. Do
not exceed the maximum recommended wattage.
Your installation is now complete. Turn on the power and test the
fixture.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
B D C G
J
K
L
H
I
A
E
F
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)