Golden Lighting 1157-6P AB - Manual

Canopy Wire Connectors Top Loop
1ea D5"×H1" 3ea P4 Orange 1ea W60 x 70mm
Chain
Junction Box
Screw
Spring Washer
1ea 6ft x4.2mm 2ea 8/32" x 1" 1ea @15 x 2mm
Chain
Connector
Nipple
2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 40mm
Mounting Strap
w/ ground screw
Hex Nut
1ea 3/4"X4" 2ea @3/8 x 3mm
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
PARTS & ASSEMBLY SHEET
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement
parts.
For Customer Service, contact the place of purchase to arrange for replacement
Canopy Loop
with Collar
F IXTURE A SSEMBLY I NSTRUCTIONS
Read and review installation instruction sheet
before assembling the fixture.
1157-6 CH/AB
1. Use Deco Nuts (S) to attach Circular End
Cap (T) to Metal Frame (N).
2. Carefully slide Glass Panels (U) into Metal
Frame (N). Then, lower the other Circular End
Cap (T) over the Metal Frame.
Note:Glass edges may be sharp. Wear gloves
for protection during installation to avoid injury.
If the glass can not be successfully placed into
the framework, please relax and adjust the iron
bar slightly. It is suggested that this be
completed by two people.
Fig. 1
PARTS LIST
Company Name:_______________________ Co. Account #:___________
to be filled out by retailer
Fixture Name: Payton 1157-6P CH/AB
This fixture assembled PO:__________ Date: ________