Golden Lighting 1157-6P AB - Manual (Page 2)

PARTS & ASSEMBLY SHEET
Fixture Name: Payton 1157-6P CH/AB
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
7. Slip Canopy loop collar (H) over the chain, then do the
same with the canopy (G).
8. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to
the canopy loop (F) and close the chain connector.
9. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
ASSEMBLING THE FIXTURE (Fig. 2)
3. Thread Threaded Stem (P) into the coupling at
centre of Fixture Body (O).
4. Thread the Top Loop (J) onto Stem (I) and (P).
Hand-tighten until snug.
5. Lower the fixture over the glass cage, use the
round Deco Nuts (M) to secure Arms (L) to the
cage (N).
6. Measure to determine the correct number of
links needed for the proper hanging height. Use a
pair of pliers to open one link of Chain (K). Then,
remove and discard the excess Chain.
7. Use one Chain Connector (L) to attach one end
of the chain to Top Loop (J) and close the chain
connector.
8. Feed the fixture wires through the chain (every
three links) and pull the wires until taut.
9. Slip Canopy Loop Collar (H) over the chain, then
do the same with Canopy (G).
10. To complete the installation, use the other
chain connector and attach the other end of the
chain to the Canopy Loop (F) and close the chain
connector.
11. Make sure the weight of the chandelier will be
supported by the chain, not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
12. Install the light bulbs (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
13. Carefully press the clips inside of Shade (Q)
onto the bulb.