Golden Lighting 1089-5 RSB-PRL - Manual

Canopy Wire connectors Top loop
1ea @5-1/2"X1-1/4" 3ea P3 Orange 1ea @3/8 x 65mm
Chain
Junction Box
Screw
Srping Washer
1ea 6ft x4.2mm 2ea 8/32" x 1" 1ea @15 x 2mm
Chain connector Nipple
2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 55mm
Mounting Strap
w/ ground screw
Hex Nut
Top/Bottom
Threaded Rod
1ea 3/4"X4" 1ea @3/8 x 45mm/@3/8 x 60mm
Top Cover Check ring Top Cap
1ea @80 x 30mm 1ea @16 x 3mm 1ea @85 x 25mm
Finial Bottom Cover Bottom Cap
1ea @3/8 x 25mm 1ea @94 x 20mm 1ea @100x45mm
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
Fig. 1
NOTE: INSTALL THE GLASS ASSEMBLY AFTER THE
FIXTURE IS HUNG.
PARTS & ASSEMBLY SHEET
1089-5 RSB
Read and review installation instruction sheet before
assembling the fixture.
F IXTURE A SSEMBLY I NSTRUCTIONS
This fixture assembled PO:__________ Date: ________
Fixture Name: Pemberly Court 1089-5 RSB-PRL
Canopy Loop
with Collar
For Customer Service, contact the place of purchase to arrange for replacement parts.
ASSEMBLING THE FIXTURE (Fig. 1)
1. If arms are together, gently spread the arms until evenly
spaced.
2. Feed the fixture wires through the top Threaded Rod (N),
Top Cover (O), Hex Nut (P), Top Cap (Q), Check Ring (R)
and Top Loop (J). Pull the wires until taut.
3. Screw the Top Threaded Rod (N) into the coupling at top
center of Fixture Frame (M).
4. Slide Top Cover (O) over Top Threaded Rod (N), secure in
place with Hex Nut (P) until tight. Slide Top Cap (Q) over Top
Threaded Rod (N) and secure in place with Check Ring (R)
until tight.
5. Screw Top Loop (J) onto the threaded center column of
Frame (M) until tight.
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note onthis sheet and contact the place of purchase to arrange for
replacement parts.
PARTS LIST
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
2ea/2ea @3/8 x 3mm/@3/8 x 5mm