GTCO Super L VI - Users Guide - Manual (Page 15)

Super L VI 15
Configuring Super L VI for Specific Applications
To configure your Super L VI for use with specific applications:
1. In Table 1, find the application program you will be using with your Super L VI. Note
the corresponding SuperSet Code.
 If your application program is not listed in Table 1, find the configuration
settings in Table 2 that your application program requires and use the
corresponding SuperSet Code.
 If an appropriate SuperSet Code is not listed in Table 2, then use the Tablet
Configuration Utilities to configure your Super L VI.
2. On the SuperSet Menu, click on the button, and then click on the two digits of
the SuperSet Code indicated for your application.
You will hear four short tones after a successful menu configuration.
Example: Configuring for a Specific Application
To configure your Super L VI to operate with Autodesk’s AutoCAD application, you would:
1. Find the entry for AutoCAD in Table 1. The SuperSet Code is .
2. Click on the button on the SuperSet Menu. You will hear one short tone,
indicating the digitizer is in Select Mode.
3. Click on the button on the SuperSet Menu. You will hear one short tone. This
enters the first digit of the SuperSet Code for AutoCAD.
4. Click on the button on the SuperSet Menu. This enters the second digit of the
SuperSet Code for AutoCAD.
You will hear four short tones, indicating that the configuration is complete. The Super L VI
is now configured to operate with AutoCAD. Select Mode is no longer active and you can
begin digitizing.
NOTE: For more information about digitizer software application driver requirements,
please visit the Technical Support section of the GTCO CalComp by Turning Technologies
website.