GTCO Super L VI - Users Guide - Manual (Page 31)

Super L VI 31
Super L VI Tones
The Super L VI produces an alarm in the form of audio tones to inform you of various
events. The table below describes the kinds of tones you might hear while operating the
digitizer.
Table 3: Super L VI Tones
*Configuration error tones or Diagnostics failed tones indicate a serious problem. If
you hear either of these tones, call GTCO CalComp by Turning Technologies Technical
Support at 1.866.746.3015.
NOTE: You might hear tones produced by the Super L VI which are actually sent by your
application program. (Programs can send commands to the digitizer to turn the audio tone
generator on and off.) If you hear tones during digitizing and they do not correspond to
the tones listed in the table above, they are produced by the application program.
Introduction to the Tablet Configuration Utilities
The Super L VI with its Controller uses the Tablet Configuration Utilities to control baud
rate, data format and other operating characteristics for the RS-232 interface. It is used to
relay configuration information to the Super L VI in cases where Table 1 and Table 2 do not
supply the information or a SuperSet Menu Code for the graphic application software being
used.