GTCO Cordless Roll-Up - Users Guide - Manual (Page 45)

Cordless Roll-Up 45
CalComp Emulation Commands
The Cordless Roll-Up recognizes a subset of the CalComp 9500 command set. Space does
not permit a detailed description of CalComp commands. However, most of the
commands in this subset have equivalent Cordless Roll-Up commands. For further
information about the operation of those commands, please refer to the Cordless Roll-Up
command or function description in the GTCO CalComp by Turning Technologies Cordless
Roll-up Command Summary.
NOTE: CalComp commands must be terminated with a <CR>, which is not shown in the
codes listed here. Commands can be strung together by substituting an @ character for
the <ESC>% sequence after the first command and postponing the <CR> until the end of
the multiple command string.