GTCO Cordless Roll-Up - Users Guide - Manual (Page 66)

Cordless Roll-Up 66
Remote Request Mode
In Remote Request Mode, one coordinate is sent when the Controller receives a Read
Current Coordinate command (CTRL-B).
To select Remote Request Mode:
Custom Configuration Menu:
GTCO Commands: Not available.
Send command RM.
Programming Example: To Ready and Display Cordless Roll-Up Formats
The following example QBASIC programs will allow users to experiment with reading and
displaying Cordless Roll-Up formats:
 To read and display ASCII formats
 To read and display high resolution binary formats
 To send version command and display results
Programming Example: To Read ASCII Formats
1. Configure the Cordless Roll-Up for 9600, N, 8, 1, GTCO ASCII, Continuous (SuperSet
74).
2. Enter and run this QBASIC program: