GTCO Summagraphics ADB Interface - Users Guide - Manual (Page 2)

Summagraphics 2
Overview
This manual is your guide to using the Summagraphics ADB interface with a large format
Summagraphics tablet. Included is information on the Microgrid III, Summagrid III,
Summagraphics LCL and Microgrid II tablets.
Parts Checklist
If you have a Summagrid III, Summagraphics LCL or Microgrid II, your ADB kit will contain
the following:
 ADB adapter box
 Tablet cable
 ADB cable
 Summagraphics ADB Utilities diskette
 User’s guide
 Software change request form
(available with user’s guide)
If you have a Microgrid III, your ADB kit will contain the following:
 ADB interface cable
 Summagraphics ADB Utilities diskette
 User’s guide
If you are missing a part, please contact GTCO CalComp by Turning Technologies at
1.866.746.3015 or email to
[email protected] .
ADB Interface for Microgrid III
Below are the steps for installing and configuring Microgrid III for use with the ADB
interface.
1. Install and configure Microgrid III as described in the user’s guide. Make sure the
Microgrid is set up to the default tablet settings.
1 2 3 4 5 6 7 8
SET 1 ON OFF OFF ON ON ON OFF OFF
SET 2 ON OFF OFF OFF OFF ON OFF OFF
SET 3 ON ON OFF OFF OFF ON ON OFF