Heli-Max HMXJ2025 - Manual (Page 10)

10
5. Rotate the ADJUST dial to adjust the speed of the servo (the higher the value the
faster the transit speed, and lower the value the slower the transit speed). NOTE: The
two position G.S switch allows you to have two gear speed settings.
6. Press ENTER to save the setting.
7. Press BACK to exit.
MIXING (CHANNEL MIXING)
The TX 610 allows three different mixing confi gurations: Delta wing, V-tail control,
and fl aperon/spoileron. Channels 1-2, 2-4 or 1-6 can be mixed.
1. Turn on your transmitter.
2. Press the MODE button for one second. You have entered model setup.
3. Dial ADJUST until you see the channel numbers and MIX icon fl ash.
4. Press MODE or ENTER and just the MIX will fl ash.
5. Turn the ADJUST dial and option 1 and the MIX will fl ash letting you know mixing is now
on. At this point you can rotate ADJUST dial to select what channel sets you wish to mix.
Number 1 mixes Channels 1-2, delta wing confi guration
Number 2 mixes Channels 2-4, V-tail control confi guration
Number 3 mixes Channels 1-6. fl aperon/spoileron confi guration
6. Press MODE or ENTER and the values will fl ash. Use ADJUST (D) to adjust the
values. NOTE: Moving the stick from left to right (or up and down) allows separate
adjustment values to either direction.
7. Press BACK to back out. This will also exit and save the settings. (NOTE: You will
notice that the MIX icon, as well as the selected mixing number, will remain illuminated,
letting you know mixing is on.
HELICOPTER SPECIFIC OPTIONS AND
ADJUSTMENTS (HELICOPTER MODE)
CCPM MIXING: (120° SWASHPLATE ARRANGEMENT ONLY)
The Heli-Max 610 allows you to mix the swashplate to compensate for either up-
down, left-right, or forward-back cyclic commands. Channel 1 represents side to
side (aileron), Channel 2 represents forward and back (elevator) and Channel 3 up
and down (Pitch). Each selection can be adjusted from -100% to +100% allowing
you full control of swashplate direction and amount of defl ection.
1. Turn on your transmitter.
2. Press the MODE button for one second. You have entered model setup.
3. Turn the ADJUST dial until you see the channel and swashplate icons fl ash.
4. Press either the MODE or ENTER button to enter this menu.
5. Turn the ADJUST dial to select the swashplate mix you want to adjust.