Heli-Max HMXJ2025 - Manual (Page 14)

14
TRAINER SYSTEM
Make sure the instructor’s transmitter is properly bound to the model, and the
instructor’s transmitter, student’s transmitter and helicopter are not powered on.
1. Connect the trainer cord to the instructor and student’s transmitter via the plug in
sockets located on the back of the transmitters. (The model must have the same setup
parameters in both transmitters)
2. Power on the student transmitter.
3. Power on the instructor’s transmitter.
4. Power up the helicopter.
5. The instructor’s transmitter will now have control of the helicopter.
6. Flip forward and hold the trainer switch to allow the student control. Relaxing switch
pressure and the instructor resumes control.
SYSTEM RESET
WARNING: This action will cause all modifi ed models and programming to revert
to factory defaults.
Press MODE, BACK and ENTER at the same time and then turn the transmitter ON.
Momentarily the transmitter will beep and all programming will be reset to default. Here
are the default settings to your transmitter:
AIRPLANE
Servo Reversing: Normal (ALL)
D/R Aileron: High 100% low 80%
D/R Elevator: High 100% low 80%
D/R Rudder: High 100% low 80%
EXPO Aileron: 0
EXPO Elevator: 0
T hrottle Curve: dot 1 (0%), dot 2 (25%),
dot 3 (50%), dot 4 (75%), dot 5 (100%)
Expo Rudder: 0
Gear Speed Slow: 25%, Fast 75%
Wing Mixing: OFF
HELICOPTER
Swash Arrangement: 90° mechanical
Servo Reversing: Normal (ALL)
D/R Aileron: High 100% low 80%
D/R Rudder: High 100% low 80%
D/R Elevator: High 100% low 80%
Revolution Mixing: OFF
EXPO Aileron: 0
EXPO Elevator: 0
T hrottle Curve: dot 1 (0%), dot 2 (25%),
dot 3 (50%), dot 4 (75%), dot 5 (100%)
Expo Rudder: 0
P itch Curve: dot 1 (35%), dot 2 (45%),
dot 3 (55%), dot 4 (65%), dot 5 (75%)
U P-1 Pitch Curve: dot 1 (30%), dot 2
(42%), dot 3 (55%), dot 4 (65%), dot 5
(75%)
G yro: Switch position back (25% non-
heading hold) Switch position forward
(75% heading hold)
Throttle Hold: 0%