Heli-Max HMXJ2025 - Manual (Page 7)

7
5. Rotate ADJUST to scroll between the two options.
6. Push ENTER to accept.
7. Press BACK to exit and save the setting.
RANGE CHECK MODE (P-H)
This allows the user to ground test the range of the radio system. (NOTE: Do not fl y
the model with the transmitter in Range Check Mode)
1. Turn the transmitter on.
2. Hold both buttons MODE and BACK down for one second for system setup.
3. Dial the ADJUST dial until you see the P-H (Power-High) icon fl ash.
4. Press either MODE or ENTER to enter power mode.
5. Turn the ADJUST dial to scroll between H (high) and L (low) power options (the
transmitter will beep letting you know you are in the low power mode).
6. Press BACK to escape and save the setting.
7. To end, cycle the power switch (WARNING: Make sure the model is inactive before
cycling the power).
NOTE: Each time you turn the transmitter on it will automatically come on in high power
mode. WARNING: DO NOT FLY THE MODEL IN RANGE CHECK MODE! This is for
ground checking the model only! (In low power mode, you should be able to maintain
a radio connection to your model at a distance of 90 feet [28meters]).
MODEL SETUP OPTIONS
SERVO REVERSING
Servo reversing allows you to change the travel direction of the servo from the
transmitter.
1. Turn on the transmitter.
2. Press MODE for one second. You have entered model setup.
3. Press either MODE or ENTER to enter the channel selection mode.
4. Turn the ADJUST dial to select between channel numbers.
5. Press MODE or ENTER to activate the menu.
6. Rotate the ADJUST dial to scroll between normal or reverse.
7. Press ENTER to save the setting.
8. Press BACK to escape and exit the program.