Heli-Max HMXJ2025 - Manual (Page 8)

8
ATV (ADJUSTABLE TRAVEL VOLUME)
ATV (Adjustable Travel Volume): The TX610 is quite unique in that it allows servo
rate travel and end point adjustments from -125% to +125% on channels 1, 2 and
4 in one menu. This system also allows a switchable high-low rate volume (D/R
Switch) with adjustable end points. Keep in mind when setting up the dual rate (D/R)
switch; one needs to adjust both transitional end-points.
1. Turn on the transmitter.
2. Press button MODE for one second. You have entered model setup.
3. Rotate the ADJUST dial clockwise until you see the channel numbers as well as the
dual rate ellipse fl ash in the lower center of the screen.
4. Press the ENTER button to select the channel you wish to change. As you can see
you can continue to press button ENTER to select and auto scroll through the channels.
5. When the value number is fl ashing you can rotate the ADJUST dial to adjust the
value. Moving the D/R switch between the forward and back position allows you to
adjust the value in either high or low rate. (Typically forward switch position is low rate
and back switch position is high rate). Moving the control stick fore and aft or left and
right allows you to see and adjust the end point adjustment within the rate.
6. When done use the BACK button to exit and save the settings.
CURVE/S
EXPO Channels 1, 2, and 4. - 5 point throttle curve on Channel 3. NOTE: The TX610
also has a 5 point pitch curve on Channel 6 (HELI ONLY). We will cover this in the
Helicopter Section of the manual.
100% 100% 0%
100% 100% 0%
Positive Expo
100% 100% 0%
100% 100% 0%
Negative Expo
100% 100% 0%
100% 100% 0%
Linear Reaction
1. Turn on the transmitter.
2. Press the MODE button for one second. You have entered model setup.
3. Turn the ADJUST dial until you see just the channel icons fl ash.
4. Press MODE or ENTER and just the fi rst adjustable channel will fl ash as well as the
current value. (Note: If no value percentage is being used, you will see 00E, meaning no
percentage value is being used in EXPO.)
5. Press the MODE or ENTER button to activate the percentage value.
6. Rotate the ADJUST dial to either a positive value or negative value.