Heli-Max HMXJ2025 - Manual (Page 12)

12
5. Rotate the ADJUST DIAL to turn the MIX feature ON (Channel 1 fl ashing) or OFF
(Channel 1 hidden).
6. Press ENTER again to enter the channel MIX menu. You will see the Channels 3 and 4
fl ashing.
7. Rotate the ADJUST dial to select which channel you want to adjust, Channel 3 or 4.
8. Press ENTER to prepare to adjust the channel.
9. Turn the ADJUST dial to set the value/s.
10. Press the BACK button to continue or exit and save the settings.
ADJUSTING THE PITCH CURVES
You can adjust the UP-1 pitch curve (some call this “Stunt Mode”). This curve allows
you to adjust the pitch range and placement of the pitch curve necessary for fl ips,
rolls and inverted fl ight.
1. Turn on your transmitter.
2. Press the MODE button for one second. You have entered model setup.
3. Turn the ADJUST dial until you see just the channel icons fl ash.
4. Press MODE or ENTER and just the fi rst adjustable channel will fl ash as well as the
current value.
5. Turn the ADJUST dial until you reach Channel 6. The channel number will fl ash with
dot below.
6. Press the MODE or ENTER button to activate the percentage value.
7. Rotate the ADJUST dial to scroll through the 5 dot points.
8. To adjust “Normal Mode”, place the HOLD/FLAP switch in the upper position. To
adjust the “UP-1 Mode”, place the HOLD/FLAP switch in the lower position.
9. Press Mode or ENTER buttons to select (fl ashing) dot percentage you wish to change.
10. Press ENTER to save and move to the next dot. You may also use the ADJUST dial
after pressing ENTER to expedite your selections.
11. To exit, press BACK to save and close.
Thr
ottle/Pitch Stick Mo
v
ement
50%
100%
0%
50%
100%
0%
Typical "Normal Mode"
5 Point Pitch Curve
1
2
3
4
5
Pitch Points (dot )
50%
100%
0%
50%
100%
0%
1
2
3
4
5
Pitch Points (dot )
Modified "UP-1"
5 Point Pitch Curve