HONDA 2004 Pilot - Owner's Manual - Manual (Page 123)

Press and hold the remote control
button and one of the HomeLink
buttons at the same time.
The remote
control you are training from may
stop transmitting after two
seconds. This is not long enough
for HomeLink to learn the code.
Release and press the button on
the remote control every two
seconds until HomeLink has
learned the code.
The red light in HomeLink should
begin flashing. It will flash slowly
at first, then rapidly.
When the red light flashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control.
Plug in the garage door opener
motor, then test the HomeLink
Transceiver button by pushing it.
If the button does not work, repeat
the procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink transceiver button you
just trained. If the red light blinks
for two seconds, then stays on,
you have a rolling code garage
door opener. Go to ‘‘Training With
a Rolling Code System’’ (see page
).
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
3.
4.
5.
6.
7.
120
Canadian Owners:
HomeLink Universal Transceiver
Comf ort and Convenience Features 119
Main Menu Table of Contents