Power windows – HONDA 2004 Pilot - Owner's Manual User Manual

Page 77

Advertising
background image

If the driver’s

window runs into any obstacle while
it is closing automatically, it will
reverse direction and then stop. To
close the window, remove the
obstacle, then use the window switch
again.

If the power windows do not operate
properly after resetting, have your
vehicle checked by a Honda dealer.

If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window fuse is removed, the
AUTO function will be disabled. The
power window system needs to be
reset after reconnecting the battery
or installing the fuse.

Start the engine. Push down and
hold the driver’s window switch
until the window is fully open.
Pull and hold the driver’s window
switch to close the window
completely, then hold the switch
for a second or two more.

Turn the ignition switch to ON (II)
to raise or lower any window. To
open the window, push the switch
down and hold it. Release the switch
when you want the window to stop.
Pull back on the switch and hold it to
close the window.

To open/close the driver’s

window, push the window switch
firmly down or up to the second
detent, and release it. The window
will automatically go up or down all
the way. To stop the window, pull/
push on the window switch briefly.

If the MAIN switch is OFF, the
passenger windows cannot be raised
or lowered. Keep the MAIN switch
off when you have children in the
vehicle so they do not injure
themselves by operating the
windows unintentionally.

1.

2.

AUTO REVERSE

AUTO

Power Windows

Instruments and Controls

73

DRIVER’S WINDOW
SWITCH

MAIN SWITCH

Closing a power window on
someone’s hands or fingers can
cause serious injury.

Make sure your passengers are
away from the windows before
closing them.

Main Menu

Table of Contents

Advertising