HONDA 2004 Pilot - Owner's Manual - Manual (Page 36)

After selecting a proper child seat,
and a good place to install the seat,
there are three main steps in
installing the seat:
All child seats must be
secured to the vehicle with the lap
part of a lap/shoulder belt or with
the LATCH (Lower Anchors and
Tethers for Children) system. A
child whose seat is not properly
secured to the vehicle can be
endangered in a crash.
After installing a child
seat, push and pull the seat
forward and from side to side to
verify that it is secure.
Rear-facing for infants, forward-
facing for small children.
Before purchasing a conventional
child seat, or using a previously
purchased one, we recommend that
you test the seat in the specific
vehicle seating position, or positions,
where the seat will be used.
Look for FMVSS
213 or CMVSS 213 on the box.
Since LATCH-compatible child seats
are easier to install and reduce the
possibility of improper installation,
we recommend selecting this style.
We also recommend selecting a
LATCH-compatible seat with a rigid,
rather than a flexible, anchor (see
page
).
In seating positions and vehicles not
equipped with LATCH, a LATCH-
compatible child seat can be installed
using a seat belt.
Whatever type of seat you choose, to
provide proper protection, a child
seat should meet three
requirements:
33
Driver and Passenger Saf ety
Selecting a Child Seat, Installing a Child Seat
Properly secure the child seat to
the vehicle.
Make sure the child seat is f irmly
secured.
The child seat should be of the
proper type and size to f it the child.
The child seat should f it the
vehicle seating position (or
positions) where it will be used.
The child seat should meet U.S. or
Canadian Motor Vehicle Saf ety
Standard 213.
1.
2.
1.
2.
3.
32
Main Menu Table of Contents