HONDA 2004 Insight - Owner's Manual - Manual (Page 98)

To Close the Hood:
Lift it up slightly to remove the
support rod from the hole. Put the
support rod back into its holding clip.
Lower the hood to about a foot (30
cm) above the fender, then let it
drop. Make sure it is securely
latched.
Pull the support rod out of its clip,
and insert the end into the hole on
the left side of the hood. Wait a few minutes after turning the
engine off before you check the oil.
Remove the dipstick (orange
handle).
Wipe off the dipstick with a clean
cloth or paper towel.
Insert it all the way back in its hole.
Remove the dipstick again and
check the level. It should be
between the upper and lower
marks.
If it is near or below the lower mark,
see
on page .
3.
3.
1.
2.
4.
133
Oil Check
Adding Oil
Service Station Procedures
Bef ore Driving 95
CLIP
SUPPORT ROD DIPSTICK
UPPER MARK
LOWER MARK
Main Menu Table of Contents