HONDA 2003 Accord Sedan - Owner's Manual - Manual (Page 318)

Turn on the headlights to test the
new bulb.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
Put the inner fender cover in place.
Install the two holding clips. Lock
each one in place by pushing on
the center.
If you are changing the bulb on
the passenger’s side, start the
engine, turn the steering wheel all
the way to the left, and turn off the
engine. If you are changing the
bulb on the driver’s side, turn the
steering wheel to the right.
Use a flat-tipped screwdriver to
remove the holding clips from the
inner fender.
Pull the inner fender cover away
from the fender and bumper.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
1. 3.
2.
4.
9.
8.
7.
6.
CONTINUED
Replacing a Front Turn Signal/
Parking Light Bulbs
Lights
Maintenance 315
HOLDING CLIPS
Main Menu Table of Contents