HONDA 2003 Accord Sedan - Owner's Manual - Manual (Page 321)

Open the trunk.
Remove the burned out bulb from
the socket by pulling it straight out
of its socket.
Remove the socket by turning it
one-quarter turn counterclockwise.
Determine which of the two bulbs
is burned out: taillight or back-up
light.
Carefully bend back the corner of
the trunk lid trim to expose the
bulbs.
Install the new bulb in the socket.
Reinstall the socket into the light
assembly.
Test the lights to make sure the
new bulb is working.
Push the trunk lid trim back into
position.
Press the trim clip back into its
hole.
Remove the trim clips from the
right or left corner of the trunk lid
trim by carefully prying them
using a small, flat-tip screwdriver
wrapped with tape.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
6-cylinder models
Replacing Rear Bulbs
(in Trunk Lid)
Lights
Maintenance 318
TRIM CLIPS BULBS
SOCKETS
BULBS
SOCKETS
Main Menu Table of Contents