HONDA 2003 Accord Sedan - Owner's Manual - Manual (Page 323)

Remove the bulb by pulling it
straight out of its metal tabs.
The ceiling light, door light and
vanity mirror light come apart the
same way, but they do not use the
same type of bulb.
Remove the lens by carefully
prying on the edge of the lens with
a fingernail file or a small flat-tip
screwdriver. Do not pry on the
edge of the housing around the
lens.
Turn on the parking lights and
check that the new bulb is
working.
Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
Put the lens back on the bulb
holder and push it until it latches.
Slide the left side of the light
assembly into the hole. Push on
the right side to latch the
assembly into place.
Ceiling light:
Pry on the front edge of the lens
near both sides.
Door light:
Pry on the top left or right of the
lens.
Spotlights:
Pry on the inner edge of both
spotlights.
Push the new bulb into the metal
tabs. Carefully snap the lens back
in place.
1.
4.
5.
2.
3.
3.
6.
Not available on DX model
Not available on DX model
Replacing Bulbs in the Interior
Lights
Lights
Maintenance 320
CEILING LIGHT
BULB
Main Menu Table of Contents