Intellijel Cylonix Shapeshifter v1.03 - Manual (Page 12)

12
Hold/1sh
Bump Sync
2=1 Sync
Examples of the oscillator 2 output in the different sync modes, with int. sync turned on. Oscillator 2
is set to sine wave. In the 1=2 Sync mode (not shown) the output of oscillator 2 would look the same
as in the Hard Sync mode, but the output of oscillator 1 in this case would look similar to the output
shown for oscillator 2 in the 2=1 Sync mode. The yellow arrows indicate the occurence of synchroni-
zation events (which can come from either the external SYNC input or from the internal sync).