Intellijel Cylonix Shapeshifter v1.03 - Manual (Page 18)

18
The TILT function phase modulates oscillator 1 with its own output. This results in a self-feedback loop which
has the effect of ‘tilting’ the waveform, as shown in the diagram below. The amount of feedback, and hence
the amount of tilting, is set by the TILT parameter. At large values of the TILT parameter the waveform may
start to become distorted, and even chaotic.
To set the nominal value of the TILT parameter, press the TILT/DRIVE button. The TILT parameter value can then
be adjusted with the rotary encoder and will be shown in the bottom row of the LCD display.
The TILT parameter can also be modulated by the MOD B input, which is activated with a second press of the
TILT/DRIVE button. When MOD B modulation is active the lower row of the LCD display will change to show
both the nominal setting and the offset provided by the MOD B modulation.
TILT FUNCTION
TILT = 00
TILT = 07
TILT = 12
TILT = 25
SINE FLUTE1 GAP SAW