Intellijel Cylonix Shapeshifter v1.03 - Manual (Page 4)

4
Front Panel Elements (continued...)
TWO-LINE LCD DISPLAY - the top row of this display is used, in various modes, to show the waveform
banks for the two oscillators, the sync mode, the pulse output source, the MODA destination, the MULTI
settings, and the chord type. When PRESET mode is active the top row of the display shows the preset
number, the preset step mode parameters, and the morph preset. The bottom row of the display is used
to show the various MODB parameter settings: the combination mode, oscillator 1 waveform tilt, echo
level, chord mode detuning, chord mode overdrive level, and the percussion mode decay time.
MOD B/MORPH POTENTIOMETER - this potentiometer provides an offset for the MOD B modulation
level. This is summed with the external MOD B input to provide the overall MOD B modulation level.
The potentiometer gives a zero value when at the 12 o’clock setting, and negative offsets when rotated
counter-clockwise and positive offsets when clockwise. When a parameter (such as the TILT level) is se-
lected to be a MOD B destination, the lower row of the display will show the current value of the modu-
lation level. When the MORPH mode is enabled while in PRESET mode, the MOD B/MORPH control will
set the level of morphing from the panel control settings to the currently selected preset values. Full
counter-clockwise gives the panel settings while full clockwise gives the preset settings.
COMBO MODE BUTTON - this button, when pressed, switches the rotary encoder to selection of the
nonlinear outputs combination modes. The encoder selected mode is displayed on the bottom row of
the LCD display. Subsequent presses of the button toggles the MOD B modulation on and off. When the
MOD B modulation is enabled the LCD display will change to show the offset to the selected mode.
TILT/DRIVE BUTTON - this button, when pressed, switches the rotary encoder to setting of the wave-
form TILT level for oscillator 1. The TILT parameter setting is displayed on the bottom row of the LCD
display. Subsequent presses of the button toggles the MOD B modulation on and off. When the MOD B
modulation is enabled the LCD display will change to show the offset to the TILT setting. When CHORD
mode is active, the output 1 DRIVE level will be set and displayed instead of the TILT level.
DELAY BUTTON - this button, when pressed, switches the rotary encoder to setting of the ECHO level.
The setting is displayed on the bottom row of the LCD display. Subsequent presses of the button toggles
the MOD B modulation on and off. When the MOD B modulation is enabled the LCD display will change
to show the offset to the echo level.
DETUNE/DECAY BUTTON - this button, when pressed, switches the rotary encoder to setting of the
detuning for oscillator 1 in CHORD mode. The DETUNE parameter is displayed on the bottom row of
the LCD display. Subsequent presses of the button toggles the MOD B modulation on and off. When the
MOD B modulation is enabled the LCD display will change to show the offset to the DETUNE parameter.
When PERC mode is active, the percussive envelope DECAY time will be set and displayed instead of the
DETUNE parameter value.
SHAPE 2 POTENTIOMETER - this potentiometer selects the waveform for oscillator 2 from the 8 wave-
forms in the currently selected wave bank. There is a smooth interpolation between the waveforms.
This setting is summed with the external SHAPE 2 modulation input to provide the actual selection.
15
16
21
20
18
19
17