Intellijel Metropolis - Manual (Page 16)

16
APPENDIX C - PATCH EXAMPLES
EXAMPLE 1: BASIC PATCH
In the EXAMPLE 1 patch the Metropolis is being used in its most common configuration to control the
pitch and amplitude of a VCO. The PITCH output from the Metropolis is connected to the 1V/Oct in-
put of the VCO. One of the VCO’s output waveforms (e.g. a saw wave) is then connected to the audio
input of a VCA.
The GATE output is connected to the gate input of an ADSR. The envelope output of the ADSR is
then connected to the CV input of the VCA in order to control the amplitude.
It is important to adjust the ADSR levels to get the desired response when the Metropolis gate length
is set to it’s minimum value. i.e. you want to make sure that it results in a short click with a tiny bit of
decay.