Figure 3. wall mounting hole locations, To mount the module in an advent cabinet, Figure 4. mounting the module in an advent cabinet – Interlogix SuperBus 2000 8Z User Manual

Page 3: To mount the module in a concord cabinet, Remove and discard the module cover (figure 2), Figure 5. support standoff, Figure 6. mounting the module in a concord cabinet

Advertising
background image

3

Installation

Figure 3.

Wall Mounting Hole Locations

To Mount the Module in an Advent Cabinet

1.

Remove AC panel power and disconnect the backup
battery(s).

2.

Remove the module cover and set it aside (Figure 2).

3.

Turn the module upside down and line up the holes on
the back-plate at the desired location (Figure 4).

4.

Secure the back-plate to the cabinet using three 1/4 -
inch #6-32 self-tapping screws (not included).

Figure 4.

Mounting the Module in an Advent Cabinet

To Mount the Module in a Concord

Cabinet

1.

Remove AC panel power and disconnect the backup
battery.

2.

Remove and discard the module cover (Figure 2).

3.

Insert a support standoff shown in Figure 5 (supplied
with panel) into the panel circuit board.

Figure 5.

Support Standoff

4.

Slide the module back-plate onto the two clips located
on the top-left corner or center of the cabinet
(Figure 6).

œÌi

The two mounting clips in the top-right corner of the
cabinet are designated for a receiver module, but if a
receiver module is not being used, the mounting clips
may be used for the 8 Zone Input Module.

5.

Push the lower-right corner of the module onto the sup-
port standoff (see detail in Figure 6).

6.

Gently press the module up and onto the cabinet side
tab.

Figure 6.

Mounting the Module in a Concord Cabinet

9712G02A.DSF

MOUNTING HOLES

REED SWITCH

HOLDER

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

MAGNET

CLIP

9712G11A.DSF

PANEL CABINET

(COVER NOT SHOWN)

MOUNTED MODULE

ROOM FOR 3RD

MODULE

MOUNT WITH

SELF TAPPING

SCREWS

SUPPORT STANDOFF

8573g64A.DSF

PANEL

END

MODULE

END

9712G08A.DSF

USABLE MOUNTING

CLIPS (6)

MOUNTED

MODULE

PANEL CABINET

(COVER NOT SHOWN)

DETAIL

SUPPORT STANDOFF

(Included with Concord

panel accessory package)

SIDE TAB

Advertising