Philips 27ce7695 - Manual (Page 12)

BT
^POVVER^
TV
DT
CONNECT
C3-
B. Television (monitor) in
combination with remote
control
Switching on {if necessary)
• Press the POWER button on the A/V
tuner amplifier.
• Press the POWER button on the
monitor.
Seiecting the TV function on the
remote controi unit
• Press the TV button.
The TV indication appears on the
display of the remote control unit.
• Press the CONNECT Q*- button.
The TV indication followed by a
programme number, or TV.C followed
by a channel number, appears on the
display of the A/V tuner amplifier.
Programme selection
Note: if necessary, put the A/V tuner
amplifier in the programme numbers
mode by pressing the VIDEO C/P
button.
Select the desired programme number
(TV station) with the digital buttons.
• First press the •/- button for
programme numbers consisting of two
digits.
• Return to one-digit programme
numbers by pressing the •/■■ button
again.
Note: When a programme number is
selected, the number and, where
appropriate, the programmed station
name, appears for about 3 seconds in
the top right-hand corner.
During stereo transmissions the word
‘STEREO’ also appears.
During transmissions in two languages,
the word ‘DUAL’ I or II appears.
Changing picture and sound
If desired, you can change colour
saturation @ COLOUR), brightness
(BRIGHTNESS), volume high notes
I (TREBLE), low notes 9> (BASS) and
balance L/R with the corresponding
buttons on the remote control unit.
Green button
After changing the picture and sound
settings, you can return to your
personal preference.
• Press the green PP button.
Picture/Contour accentuation
Depending on your preference, you can
switch on the picture/contour
accentuation.
Switching on (remote control should
be in TV mode)
• Press the CRISP button.
The CRISP indication on the monitor
lights up.
Switching off
• Press the CRISP button again.
The CRISP indication goes off.
Language seiection
For dual-language transmissions the
indication DUAL I or II will appear when
the corresponding programme number
is selected.
• Press the DUAL I button to hear the
other (2nd) language.
• Press the DUAL button again to
select the 1st language.
SOUND SELECTION
” V
O
O
MONO
LOUDNESS OtLOFF
Spatial sound with stereo
signals
• Press the SPATIAL button.
The QO indication on the A/V tuner
lights up.
• Press the SPATIAL button again to
switch off this effect.
Note: For this, the A/V tuner amplifier
must not be in MONO mode. (If
necessary, press the MONO ON/OFF
button.)
Muting
• Press the MUTE button.
• Press the MUTE button again to
resume sound reproduction.
Time indication
• Press the 9 (SUBCODE) button.
If it is transmitted, the time appears in
the top right-hand corner of the screen.
• Press the 9 (SUBCODE) button
again to remove the time.