Philips 27ce7695 - Manual (Page 22)

The multifunctional system remote
control
This multifunctional remote control can be used for the A/V tuner
amplifier and monitor (and any other connected equipment from
our series), which work on the present standardised (RC5)
operating signals.
The receiver of the remote control signals is buiit into the
monitor. The A/V tuner amplifier, in combination with the monitor,
receives the signals from the remote control unit via the
Eurocable. The monitor should be in standby mode or shouid be
switched on to receive the signals from the remote control unit.
Remote control unit
Inserting batteries
• Open the flap and remove it.
Brief description of the buttons and functions
1. Source selector buttons*
VIDEO
Button Indica­
tion
TV
VCR
EXT1
EXT 2
AUDiO
TV
VCR
SAT
CDV
Button Indica­
tion
A-TU
TAPE
AUX 1
AUX 2
A-TU
TAPE
PHON
CD
Function
switching over to TV
switching over to video recorder
switching over to Satellite Tuner
switching over to CD Video Player
Function
switching over to Radio
switching over to Audio Cassette Recorder
switching over to Record Player
switching over to Compact Disc Player
* After the source is selected, the CONNECT button should be
pressed to reproduce the source.
If you only select the source on the remote control unit and you
do not press the CONNECT button, you can only operate the
functions of the selected source (e.g. video recorder) via the
remote control unit.
2. Digit buttons 0 to 9
For selecting a one-digit number, press directly 0 to 9.
For selecting a two-digit number, first press the button and
then the number (e.g. 10 to -).
To select a teletext page, first press a three-digit number.
3. Picture and sound —/-f and baiance L/R buttons
Button Function
COLOUR colour saturation
BRIGHT picture brightness
TREBLE high notes
BASS low notes
L/R balance (division of sound)
FRONT/REAR balance when the Dolby Surround Processor Is
used
VOLUME sound level
4. Teletext buttons
Button Function
TELETEXT switching on Teletext
ENLARGE double height
HOLD stopping rotating pages
REVEAL calling up hidden information
CANCEL ‘temporarily’ cancelling Teletext
NEXT calling up page numbers from the memory
ENTER entering page numbers in the memory
MIX Teletext together with TV programme
SUBCODE calling up page numbers at set time and directly
selecting a rotating page number
5. Tape transport buttons for audio and video equipment
(The functions in bold (picture) are only for video equipment)
Button Function
PAUSE temporarily interrupting picture and sound
recording/playback
REWIND winding the tape backward
PLAY starting picture and sound playback
WIND winding the tape forward
RECORD recording picture and sound
REVERSE fast picture in reverse
STOP stopping picture and sound
FORWARD fast picture forward.
6. Other function buttons
Button
STANDBY
Function
switching off picture when the remote control is
in position TV.
Switching off picture and sound when the
remote control is in position A-TU.
making various function indications visible via
the monitor
switching on picture/contour accentuation
selecting 1st or 2nd language (original or
dubbed language)
sound with extra spatial effect
(green button) returning to preferred personal
setting of picture or sound/autotracking VCR
muting sound.
OSD
CRISP
DUAL
SPATIAL
PP
MUTE
Only if the remote control is in position TV:
PIP
on/off
SELECT source selection PIP picture
SWOP swopping main picture and PIP picture
SHIFT shifting PIP picture
FREEZE freezing PIP picture.
7. Function buttons A, B, C and D
With these buttons you can select preprogrammed operating
functions (see code table).
18