Juniper Systems Allegro DOS Manual - Manual (Page 175)

MS-DOS Page 5-15
<F4> MkDir: This command is used to create a new subdirectory in the
current directory path. When <F4> is pressed, you are asked to enter the
name of the new subdirectory on the second status line. Enter the name
and press <ENTER>.
<F5> Xfer: Use this function to set up communication parameters and
establish communication between the Allegro and another computer.
When you press <F5> the following communication functions are
shown:
Function Description
F1 = COM Port Set Up Communication Port
F2 = Baud Select Baud Rate
F3 = Cmd Access the Commands
F4 = Recv Receive Files From PC
F5 = Send Send Files to PC
F6 = Lynx Toggle Lynx On and Off
Refer to Establishing Communication Between Computers and
Communicating with Other PC Programs earlier in this section for details
about these functions.
<F6> Move: This command moves a file or a group of files to other
drives or directories. Highlight a file or mark a group of files to be
copied using <Ins> and press <F6>.
You are asked to enter the destination for the files to be moved to on the second
status line. Enter the destination path (drive and directory). Press <ENTER> to
move the file(s).
❖ Note: You cannot move files to the ROM drive (A:)
<F7> Rename: To rename a file, highlight the desired file and press
<F7>. Enter the new filename and press <ENTER>. If you do not want a
filename to have an extension, type the filename ending with a period.
For example, “MYFILE.” would be listed in the directory without an
extension.
<F8> Mark All: Marks all the files on the current directory.
<F9> Unmark All: Unmarks all the files on the current directory.