Juniper Systems Replacing the Communications Module on the Field PC - Manual (Page 2)

8. Once each screw is loose, return to the first
screw and place the hex wrench so the
tall end is on the screw head (see Fig. 3).
Remove the screw from the slot.
Figure 3: Placement of the hex wrench to
finish loosening screws
9. Repeat Step 8 for the other three screws.
Note: The communications module
becomes loose after you have removed the
fourth screw.
10. Once you have removed the old module,
set the new communications module in
place on the Field PC, as shown here.
Figure 4: Correct placement of the
communications module
11. Replace the four communications module
screws as follows:
First turn the device upside down so the
handstrap latch hangs below the Field
PC (see Fig. 5).
Place a screw head on the tip of the hex
wrench to position the screw in place. •
•
Lift the Field PC to eye level.
Insert the screws into the screw slots, as
shown in Figure 5.
Figure 5: Replacing the screws
Tighten each screw loosely before
inserting the next screw. After all of the
screws are in place, go back and tighten
each screw firmly.
CAUTION: It is possible to over-tighten
the screws and strip the screw hole
threads. To avoid this, tighten the
screws using the long end of the hex
wrench on the screw heads as shown
in Figure 3. If you accidentally strip the
threads, contact your service center to
schedule a repair.
12. Replace the body molding and four side
screws. To properly seal the body molding
on the Field PC, tighten the screws until
they become snug and then apply an extra
1/8 turn.
13. Replace the bottom latch of the hand strap.
•
•
•
P/N 15273-00.
Copyright 12/2006. Juniper Systems, Inc. All rights reserved.
Information in this document is subject to change without
notice.