Canon AXIS 1610 - Manual (Page 31)

AXIS 1610 User’s Manual Section 3: Installation 31
The AXIS NetPilot Installation Wizard guides you through the
installation process. The following options are available:
Printer Port Name The default printer port name consists of <name>, where
<name> is AXIS followed by the last six digits of the AXIS 1610
serial number, e.g. AXIS100086. If you want to change the
default printer name, just type the new name in the available
text field. The maximum length of the printer port name is 15
characters. If you enter more than 15 characters, the name will
be truncated.
IP address If you want to assign an IP address to your AXIS 1610, indicate
which method the AXIS 1610 should employ for obtaining an IP
address. DHCP, ARP, RARP and BOOTP are supported. You can
also set the IP address manually. Refer to Assigning an IP
address, on page 16 for more information.
Set Configuration
Password
The final user prompt in the Installation Wizard allows you to
set a password that protects the AXIS 1610 parameters and
settings from unauthorized users.
Notes: ❏ The parameters entered during installation are not permanent,
they can be altered at any time according to your network
printing requirements.
❏ No serious or permanent damage will be caused if you make a
mistake during installation. If at any time you find that printing
is not satisfactory, the parameters can easily be changed to tune
the system to your requirements.