Canon AXIS 1610 - Manual (Page 36)

Section 4: Management & Configuration AXIS 1610 User’s Manual 36
Using Netspot
The Canon NetSpot utility provides easy network management
of your devices by allowing you to set up those devices and
display device status and features.
Installing NetSpot Before installing NetSpot, refer to the NetSpot user
documentation, provided with the NetSpot software, with
information on the installation procedure and the minimum
requirements for NetSpot.
Viewing AXIS 1610
using NetSpot
As NetSpot communicates with the AXIS 1610 via the TCP/IP
protocol (and SNMP), it is necessary to configure the TCP/IP
settings of the AXIS 1610 as described in Assigning an IP
address, on page 16. Alternatively, you can configure these
settings using NetSpot as follows:
1. Start NetSpot.
2. From the Device menu, select New...
3. Type the MAC address (Ethernet address) of the AXIS 1610 and
the IP address you want to assign to the AXIS 1610, and select
the
Continue... button.
4. Select the frame type of your TCP/IP network, and click the Add
to List button.
Notes: ❏ If you want to configure the TCP/IP settings of the AXIS 1610
using NetSpot, it is necessary to use the Administrator version of
NetSpot. See the NetSpot user documentation for more
information.
❏ If you use DHCP, RARP or BOOTP for the IP address, use a
temporary IP address in step 3 of the procedure. Reconfigure the
TCP/IP settings after completing the procedure.