Kenton Plugstation ver.2.01 - Manual (Page 22)

KENTON PLUGSTATION USERS MANUAL
22
DIAGRAM 15: INSERTING THE SW1000XG WITH X BOARD
DIAGRAM 16: THE X-BOARD IN CLOSE UP
Using the plastic spacers supplied with your PLG cards, carefully attach the KENTON X-BOARD to the side
of the SW1000XG, and then attach the PLG interface cable from the SW1000XG PLG interface slot to the
interface connector on the KENTON X-BOARD.
DIAGRAM 17: X-BOARD FITTED TO SW1000XG
Now, being careful to check the orientation, connect the KENTON D-SUB plate connector to the D-SUB
connector on the KENTON X-BOARD. The plate should then be facing in the same direction as the
SW1000XG plate (by plate we mean the front of the SW1000XG where the audio connections are), in other
words, the 44-WAY connector should be facing the same way as the AUDIO and MIDI ports on the
SW1000XG. (See DIAGRAM 18)