Kenton Plugstation ver.2.01 - Manual (Page 36)

KENTON PLUGSTATION USERS MANUAL
36
YOPS – THIS IS THE Y-BOARD INDIVIDUAL OUTPUT SELECT OPTION. This parameter is again only
effective if you have the optional Y-BOARD fitted to the PLUGSTATION. The parameter allows you to
assign each PLG card to a pair of individual outputs on the back of PLUGSTATION. This is useful if you
wish to combine the sounds of 2 PLG cards through your mixer, and treat them with the same EQ or effects
settings on your external mixer. To set 2 PLG cards to the same outputs, use this menu whilst editing 2
different PLG cards, and set the outputs to the same value. For example, if you had a PLG100VL in slot 1 ,
and a PLG100DX in slot 2, the default output settings for the VL would be 1-2, and for the DX would be 3-4
(this indicates outputs 1&2 and outputs 3&4 respectively). If you wished to have the sound of both PLG
cards coming out of the same outputs, you could set the YOPS value for the DX card to 1-2, thus forcing the
sound for this PLG card to be fed to the 1&2 outputs on the back of PLUGSTATION. This is useful if you
have a smaller mixer which may not have 8 individual inputs, or that you may only have a few inputs left on
your larger mixer. It is also useful if you wish to separate the outputs from the SW1000XG audio (if the Z-
board is fitted) or synth parts from the outputs of the PLG cards for applying different effects or EQ settings
with your external mixer. The values for this parameter are 1-2 = OUTPUTS 1&2, 3-4 = OUTPUTS 3&4, 5-6
= OUTPUTS 5&6 and 7-8 = OUTPUTS 7&8.
EXAMPLE OF OUTPUT 1&2 SELECTION