Kenton Plugstation ver.2.01 - Manual (Page 47)

KENTON PLUGSTATION USERS MANUAL
47
STOR – Stores a global or performance setup to one of 64 locations or stores the GLOBAL settings made
(such as YOPL levels for example) (VALUE RANGE 1-64 & GLOBAL). Global will store the current
global settings for the unit.
NOTE: HOLDING DOWN THE DATA ENTRY BUTTON IN THIS MENU FOR 2 SECONDS WILL DROP
THE SCREEN TO THE MAIN STATUS PAGE, BE CAREFUL NOT TO PRESS FOR TOO LONG ON THE
STORE PAGE AS THIS WILL HAPPEN AND MAY BE CONFUSING.
NOTE: PERFORMANCE MEMORY LOCATIONS WILL NOT (AS IS THE CASE WITH SOME OTHER
YAMAHA PLG HOSTING DEVICES) STORE EDITS MADE USING COMPUTER SOFTWARE. THESE
MUST BE LOADED BACK IN FROM THE SOFTWARE YOU CHOSE TO USE. FOR EXAMPLE, IF YOU
USE XGWORKS PLUG IN EDITORS FOR PLG100 OR 150 SERIES CARDS SUCH AS THE PLG150DX
WITH THE DX SIMULATOR, ANY EDITS YOU SEND TO THE PLG150DX CARD FITTED TO
PLUGSTATION WILL BE LOST ON POWER DOWN.
PARAMETER EDITING MODE NOTES AND TIPS.
As the PLUGSTATION has limited screen space, it can sometimes get confusing navigating around the
various menu options. If you at any point get lost or stuck, then the last value you have entered will be safe,
and you can always (except in PRGS mode) escape back to the top level menu by holding down the DATA
ENTRY knob for a few seconds until the DOT LED is in either the CARD level, or the STATUS level (where
the boards fitted are shown by a line for each cards lot in the lower portion of the LED. In future full software
support such as XGPAD will support not only the PLG card editing, but also control of all of
PLUGSTATION’s own functionality.