Kuzma Stabi - Manual (Page 10)

_________________________________________________________________
S T A B I T U R N T A B L E 10 KUZMA
4. Platter
a) Before positioning platter, check that top surface of subplatter and underside of
platter are both dust free.
b) Gently lower platter into spindle.
c) Platter will now be in a raised position and it must be lowered to give an
approximate clearance of 2 mm (ie approximate thickness of belt) between bottom
surface of platter and turntable top. If platter is too low, raise by screwing black
knobs clockwise (Fig. 6)
d) This is achieved by unscrewing (anticlockwise) two diagonal black knobs (A) on
turntable top and then the other diagonal pair (B). This operation should be done
in small gradual stages ie, a few turns of one diagonal pair (A) then a few turns of
the other pair (B) untill the level is slowly brought down to a suitable clearance.
Often, however, one part of platter is clearly higher and the knob closest to that
part should be unscrewed separately until platter is parallel with plinth (Fig.7)
Fig. 6
HINT: While unscrewing one diagonal pair your eye position should be at platter
level between that pair ie just to the side of front konob of the other diagonal pair.