Kuzma Stabi - Manual (Page 17)

_________________________________________________________________
S T A B I T U R N T A B L E 17 KUZMA
IV. ADJUSTMENT
1. Positioning Turntable and Power Supply
a) Suitable surfaces are:
i) If floors are solid, a solid welded table, sand filled or purpose built turntable table.
ii) If floors are not solid - on a welded shelf.
iii) If neither of these options are available, avoid placing on heavy bulky furniture
and place on strong but lightweight surface.
b) Disconnect power supply and remove platter.
c) Decide whether you will remove the protective cups on feet to expose the spikes
(for optimum performance) or retain the cups. Cups are removed by simply pulling
downwards. Ensure that rubber ring is not mislaid.
NOTE: To replace cups, first carefully place rubber ring around groove on spiked feet
then push on cup, one edge at a time. The cup will be loose. (Fig. 13)
d) When carrying turntable, a tilt of up to 15° should not cause any oil spillage. Mo-
mentary larger angles of tilt are also acceptable due to the viscosity of the oil.
(Fig. 14)
e) Position of power supply is not particularly critical though we do not recommend
it be placed on the right side of the turntable and that there is a minimum clearance
above unit of approximately 50 mm, due to the heat generated.