Kuzma Stabi - Manual (Page 27)

_________________________________________________________________
S T A B I T U R N T A B L E 27 KUZMA
1. Unplug turntable from mains.
2. Remove platter.
3. Unscrew the two screws securing tonearm cable to subchassis and turntable frame
and remove tonearm.
4. Unscrew four black knobs and remove.
NOTE: If subchassis is not on solid table be prepared for release of spring reservoirs.
The subchassis will remain on table.
5. Lift turntable body and lid and place on its left side with lid open. In this position
access to motor can be obtained from above and below.
6. Mark position of motor. (Fig. 3)
7. The motor is held by two nuts and bolts which should be loosened by holding bolt
with pliers and unscrewing slightly with screwdriver or by using spanner (M3
screw).
8. Move motor outwards for 2 - 3 mm from previous position and retighten nuts and
bolts.
9. Return turntable to position over subchassis and rescrew black knobs.
10. Lift subchassis by use of black knobs.
Return subplatter, platter and belt.
Adjust platter to appropriate level.
Check start of platter rotation.
11. If start is not satisfactory, reposition motor.
12. If start is satisfactory return tonearm adjust platter height and secure cable.
F. Movement of Subchassis while Platter is Rotating
The subchassis should stop oscillating 7 - 10 seconds after the motor is started
(providing there is oil in spring reservoirs).
If there is movement after this time, check the tension of the belt of if there is oil on
the belt or grooves.