Kuzma Stabi - Manual (Page 7)

_________________________________________________________________
S T A B I T U R N T A B L E 7 KUZMA
III. ASSEMBLY
Place turntable on convenient worktable.
1. Oil in Suspension Reservoirs
You will need larger oil bottle, tissue, scissors.
a) Unscrew top of oil bottle and snip of 5 mm off nozzle.
b) Position turntable so that one corner extends over edge of table. From underneath
you will see around black plate which is the bottom of reservoir (Fig. 3)
c) Open lid. With one hand unscrew black knob (anticlockwise) on turntable top that
lies immediately above reservoir, supporting reservoir with fingers to revent
turning. Continue unscrewing until knob is released and can be removed. At this
point reservoir will drop into your hand. (Fig. 4)
d) In centre of reservoir is a hole in the inner ring through which the thick silicon oil
should be slowly poured, squeezing the bottle, until surface of the oil shows
approximately 10 - 15 mm below the top edge of reservoir (ie quarter of bottle).
Allow oil to settle and check level by pushing ring sideways with nozzle of bottle
(Fig. 4a)
e) Wipe clean any spillt oil.
f) Wipe dust on top edge of surface of plinth.
g) You will notice that the inner ring is not central. It is recommended that the side
closest to the edge should be directed towards the centre of turntable. Firmly
reinsert reservoir back into the turntable from underneath and support while you
rescrew (clockwise) the black knob until reservoir is fixed.
NOTE: Knob should be tightened until slight counter pressure can be felt.
NOTE: When moving turntable to reposition, always close lid.
h) Repeat procedure for remaining three reservoirs.
NOTE: Oil used is silicon oil 5000 or oil of a similar viscosity.