Kuzma Stabi - Manual (Page 25)

_________________________________________________________________
S T A B I T U R N T A B L E 25 KUZMA
VII. MINOR PROBLEMS
If any problems occur with your turntable do not hesitate to contact your dealer. It
may, however, be convenient to be able to make a few checks and adjustments
yourself.
A. Immobile Subchassis
1. Check turntable has been uppacked correctly, ie. the four cardboard inserts at
corners have been removed.
2. Check tonearm cable is not too tight or too long.
3. Check clearance between platter and turntable.
4. Check clearance between subchassis and shelf or table!
B. Platter does not Rotate
1. Check mains. Is red light showing on power supply?
2. Is light showing on turntable? If not check that cable is connected to power supply,
if so consult your dealer.
3. Remove platter and check that belt is correctly positioned. Also see if motor pulley
is rotating clockwise.
4. By hand rotate subplatter which should move easily. If it does not then remove
shaft
and check bearing for dirt deposits by removing oil with a plastic tube. Clean shaft
and put clean oil in bearing.
C. Noisy Belt
When the turntable starts there may be some noise which rapidly ceases and this is
unimportant. If, however, a crackling sound is heard when the platter is fully rotating
then check height of the platter.
D. Cleaning of mat
Use rollers for cleaning cloth, rolling it over the surface of the mat.