Kuzma Stabi User Manual
Page 13
_________________________________________________________________
S T A B I T U R N T A B L E
13
KUZMA
6. Testing
a) With finger push spindle down gently to ensure subchassis has freedom of
movement. Platter should oscillate for a few seconds.
b) Plug into mains supply. Switch on at rear of power supply. Red light should appear
on front panel (Fig. 9)
OR
If turntable is designed for use without power supply then connect cable to mains.
c) Switch on to 33 rpm position. Light should appear on turntable top plate. (Fig. 10)
OR
Press black play switch. Platter should slowly rotate and reach full speed in 5 - 6
seconds.
d) There should be no noise from turntable.
If there is, check that assembly instructions have been followed exactly, paying
particular attention to height of platter and position of belt.
WARNING: If turntable is designed for use with power supply, the 5 pin connector
should on no account be connected directly to the mains.