Kuzma Stabi - Manual (Page 18)

_________________________________________________________________
S T A B I T U R N T A B L E 18 KUZMA
2. Connections
(See Fig. 8)
a) Reconnect power supply.
b) Connect thin black grounding wire from turntable to GND on preamplifier.
c) Plug tonearm connectors to preamplifier Phono Input. (white - left, red - right)
and tonearm grounding cable to GND on preamplifier.
3. Levelling Turntable
a) Ensure turntable is horizontal using spirit level.
b) Place level at front of turntable top (position A) and adjust front legs until level is
horizontal. (Clockwise raises turntable, anticlockwise lowers) (Fig. 15)
c) Repeat, now placing level on left of platter. (Position B)
d) Check that front of turntable is still horizontal and adjust if necessary.
e) Check that side of turntable is still horizontal, adjust as necessary until both
measurements are stable.
NOTE: If using round spirit level, place at any point on turntable top plate.
f) With Alan key 2,5 mm secure legs until firm but not overtightened. See Fig. 13
4. Levelling Platter
(See Figs 6 and 7)
Platter can be levelled by eye, although a very light spirit level can be used if
available. Adjust level of platter using technique previously described (4d Assembly)
until gap between platter and top plate is approximately 2 mm and horizontal.
5. Testing
Start turntable and ensure running is smooth and noise free.
NOTE: We advise “running in” turntable for approximately 24 hours.